Ping-tﾓﾊﾞｲﾙ助け合いﾌｫｰﾗﾑ

ﾚｽ

前ﾚｽ

元ﾄﾋﾟ

次ﾚｽ

ﾀｲﾄﾙ

Re: RemMAC LocMAC表示出来ない

ﾌｫｰﾗﾑ

CCNA全般

投稿ﾕｰｻﾞ(投稿日)

(2016/9/22)

本文

気になった点をｺﾒﾝﾄします｡

-----引用(始)-----

Router(config)#interface FastEthernet0
Router(config-if)#no ip address
Router(config-if)#duplex auto
Router(config-if)#speed auto
Router(config-if)#pppoe enable
Router(config-if)#exit

-----引用(終)-----

pppoe-client dial-pool-number 1
が必要かと思います｡

-----引用(始)-----

Router(config-if)#ppp authentication cahp callin

-----引用(終)-----

chapのｽﾍﾟﾙがおかしいです｡

-----引用(始)-----

Router(config)#ip rorte 0.0.0.0 0.0.0.0 Dialer1

-----引用(終)-----

route のｽﾍﾟﾙがおかしいです｡

ちなみに私は上記を修正したら､1812Jで接続できましたよ｡

-----引用(始)-----

Router#sh ver | inc C181X
Cisco IOS Software, C181X Software (C181X-ADVENTERPRISEK9-M), Version 15.1(4)M7, RELEASE SOFTWARE (fc2)
Router#sh run int fa0
Building configuration...

Current configuration : 131 bytes
!
interface FastEthernet0
no ip address
duplex auto
speed auto
pppoe enable group global
pppoe-client dial-pool-number 1
end

Router#sh run int dial 1
Building configuration...

Current configuration : 257 bytes
!
interface Dialer1
ip address negotiated
ip mtu 1454
ip nat outside
ip virtual-reassembly in
encapsulation ppp
dialer pool 1
dialer-group 1
ppp authentication chap callin
ppp chap hostname XXXX@XXXX
ppp chap password 0 XXXXXXXX
end

Router#ping 8.8.8.8
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 8.8.8.8, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 8/8/8 ms
Router#

-----引用(終)-----

ﾚｽ一覧

前ﾚｽ

元ﾄﾋﾟ

次ﾚｽ

Ping-tﾓﾊﾞｲﾙTOP